Skip to main content


Belt Tear Switch (BTS 202) is used for detecting the torn Belt and provide potential free contacts for the necessary control action. The control action may be in the form of Alarm OR tripping of the Belt Drive. 

  Low Cost & Reliable
  No Power supply required
  Simple installation & easy to maintain
  Manual Reset
  Robust Cast Aluminium Enclosure. DMC (Dough Moulding Compound) Enclosure also available, which is more sutable in costal area, chemical / corrosive atmosphere.

Output Contacts : 2NO+2NC
Contact Rating : 16 Amp at 440V AC on resistive load. They are suitable for lower rating also. (e.g. 5A at 240V AC)
Termination : Suitable to accept 2.5 mm sq conductors. Separate earthing studs are provided
Reset : Manual
Enclosure : DMC or Cast Aluminium, Dust and Water tight to IP – 65 grade.
Cable Entry : 2 Nos., 3/4" BSC cable entries shall be provided.

This switch finds wide application for preventing the snapping of Conveyor Belts used in Material Handling System.